Your Ad Here

Wednesday, April 27, 2011

Xbox Laptop - The Case (Pt.3)

The motherboard stand-off's.

This is going to be pretty simple and extremely basic...
-I used 1 clear Bic pen, cut it into 4, 5/8" pieces.
-Then I took 4 of the best stand-off's that I removed previously and sanded them to where they'd fit into one end.
-I super-glued the black piece into one end, then filled the rest with hot glue.
-I screwed all 4 NEW stand-off's into all 4 corners of the motherboard.
-While up-side-down (right-side-up) I quickly dabbed all 4 stand-off's, flipped it and placed it.
-I held all 4 corners down with my fingers as tightly as I could until I felt that they were set enough for me to back out the screws.
-Once the screws were backed out and the mother board was removed I gobbed all 4 new posts with a generous amount of hot glue.
-I cracked open a beer, drank it and let the glue set before I attempted to set the motherboard back down.



Continued in part 4...

6 comments:

  1. This comment has been removed by a blog administrator.

    ReplyDelete
  2. This comment has been removed by the author.

    ReplyDelete
  3. This comment has been removed by a blog administrator.

    ReplyDelete
  4. This comment has been removed by a blog administrator.

    ReplyDelete
  5. This comment has been removed by a blog administrator.

    ReplyDelete
  6. This comment has been removed by a blog administrator.

    ReplyDelete